124 CHAPTER 9: GARP&GVRP C ONFIGURATION COMMANDSAfter every GARP application entity is started, the LeaveAll timer will be startedsimultaneously. The GARP application entity will send LeaveAll message after thetimer times out to make other application entities re-register all attributeinformation on the entities themselves. Then, the LeaveAll timer is started and thenew cycle begins.Related command: display garp timer.Example# Set GARP LeaveAll timer to 1s.[SW8800] garp timer leaveall 100reset garp statistics Syntaxreset garp statistics [ interface interface-list ]ViewUser viewParameterinterface-list: Specifies a list of Ethernet ports on which the GARP statisticsinformation will be cleared, expressed as interface-list = { interface-typeinterface-number [ to interface-type interface-num] }&<1-10>. interface-type isinterface type, and interface-number is interface number. The interface-numberafter the keyword to must be larger than or equal to that before to. &<1-10>means that the preceding parameter can be repeated up to 10 times.DescriptionUse the reset garp statistics command to reset the GARP statistics information(such as the packets received/sent and discarded by GVRP/GMRP). If the commandhas no parameter, it will clear the GARP statistics information of all the ports.Related command: display garp statistics.Example# Clear GARP statistics information. reset garp statisticsGVRP ConfigurationCommandsdisplay gvrp statistics Syntaxdisplay gvrp statistics [ interface interface-list ]ViewAny viewParameterInterface-list: List of Ethernet ports on which the GVRP statistics information is tobe displayed, expressed as interface-list = { interface-type interface-number } [ to
