Password Control Configuration Commands 1093Use the password-control login-attempt attempt-time exceed command toconfigure the processing mode used after password attempt fails.Example# Configure the aging time of the system login passwords to 100 days.system-viewSystem View: return to User View with Ctrl+Z.[SW8800] password-control aging 100# Configure the minimum length of the system login passwords to 8 characters.[SW8800] password-control length 8# Configure the number of password attempts allowed for each user to 5.[SW8800] password-control login-attempt 5# Configure the maximum number of history password records allowed for eachuser to 10.[SW8800] password-control history 10# Configure the alert time so that users are alerted 7 days before their passwordsexpire.[SW8800] password-control alert-before-expire 7# Configure the timeout time of the user password authentication to 100 seconds.[SW8800] password-control authentication-timeout 100# Configure the processing mode so that the system locks the user after failedpassword authentication attempts and allow the user to log in to the switch again360 minutes later.[SW8800] password-control login-attempt 3 exceed locktime 360password-control enable Syntaxpassword-control { aging | length | history } enableundo password-control { aging | length | history } enableViewSystem viewParameterNoneDescriptionUse the password-control enable commands to enable the password controlfunction of the system. The specific usage is as follows:
