PIM Configuration Commands 633neighbor-address: Neighbor address.interface interface-type interface-number: Specifies interface.DescriptionUse the reset pim neighbor command to clear a PIM neighbor.Related command: display pim neighbor.Example# Clear the PIM neighbor 25.5.4.3. reset pim neighbor 25.5.4.3reset pim routing-table Syntaxreset pim routing-table { all | { group-address [ mask group-mask |mask-length group-mask-length ] | source-address [ mask source-mask |mask-length source-mask-length ] | { incoming-interface interface-typeinterface number | null } } * }ViewUser viewParameterall: All PIM neighbors.group-address: Group address.mask group-mask: Specifies group mask.mask-length group-mask-length: Mask length of the group address.source-address: Source address.mask source-mask: Specifies source mask.mask-length source-mask-length: Specifies mask length of the group address.incoming-interface: Specifies incoming interface for the route entry in PIMrouting table.interface-type interface-number: Interface type and interface number, used tospecify the interface.DescriptionUse the reset pim routing-table command to clear a PIM route entry.You can type in source address first and group address after in the command, aslong as they are valid. Error information will be given if you type in invalidaddresses.If in this command, the group-address is 224.0.0.0/24 and source-address is theRP address (where group address can have a mask, but the resulted IP address
