1020 CHAPTER 60: I NFORMATION CENTERDescriptionUse the info-center timestamp command to configure the timestamp outputformat in debugging/trap information.Use the undo info-center timestamp command to disable the output oftimestamp field.By default, date stamp is used.Example# Configure the debugging information timestamp format as boot. system-viewSystem View: return to User View with Ctrl+Z.[SW8800] info-center timestamp debugging bootinfo-center trapbuffer Syntaxinfo-center trapbuffer [ size buffersize | channel { channel-number |channel-name } ]*undo info-center trapbuffer [ channel | size ]ViewSystem viewParametersize: Configures the size of the trap buffer.buffersize: Size of trap buffer (numbers of messages).channel: Configures the channel to output information to trap buffer.channel-number: Channel number, ranging from 0 to 9, that is, the system has tenchannels.channel-name: Channel name which can be the channel7, channel8, channel9,console, logbuffer, loghost, monitor, snmpagent, trapbuffer, logfileDescriptionUse the info-center trapbuffer command to output information to the trapbuffer.Use the undo info-center trapbuffer command to cancel output information totrap buffer.By default, output information is transmitted to trap buffer and size of trap bufferis 256, that is, the trap buffer can hold 256 messages.This command takes effect only after the system logging is enabled.The information can be output to the trap buffer by configuring the size of thebuffer.