VPLS Configuration Commands 785DescriptionUse the rule permit mpls l2label-range command to add a rule for the LinkACL. The MPLS label range ID corresponding to the rule is range-id. In this case,the corresponding label range is 128K + range-id Ðó 16K ~ 128K + (range-id + 1)Ðó 16K - 1. If no range-id is provided, by default, the label range corresponding tothe rule is 128K ~ 256K - 1.Example# Create a rule of the Link ACL. The label range corresponding to the rule is 128K~ 256K - 1. system-view[SW8800]acl number 4000[3Com-acl-link-4000] rule 0 permit mpls l2label-rangevpls-load-share Syntaxvpls-load-share enablevpls-load-share disableViewSystem viewParameterNoneDescriptionUse the vpls-load-share enable command to enable VPLS load sharing and allowVPLS module switchover upon failure.Use the vpls-load-share disable command to disable VPLS load sharing andprohibit VPLS module switchover upon failure.By default, VPLS load sharing is enabled; that is, switchover upon failure isallowed. If the service on a VPLS module has been switched over to anothermodule, you cannot prohibit switchover upon failure.Example# Enables VPLS load sharing. system-view[SW8800] vpls-load-share enablepwsignal Syntaxpwsignal [ ldp ]ViewVSI viewParameterldp: Configures the VSI to use LDP as the PW signaling protocol.
