1-5Use the undo databits command to revert to the default databits.The default databits is 8.z This command takes effect on AUX user interfaces only.z The databits setting on the terminal and that on the device user interface must be the same forcommunication.Examples# Set the databits to 7. system-viewSystem View: return to User View with Ctrl+Z.[Sysname] user-interface aux 0[Sysname-ui-aux0] databits 7display telnet-server source-ipSyntaxdisplay telnet-server source-ipViewAny viewParametersNoneDescriptionUse the display telnet-server source-ip command to display the source IP address configured for theswitch operating as the Telnet server. That is, when the switch operates as the Telnet server, the clientuses this IP address to log in to the switch.z If the source IP address or source interface is specified for the switch, this command displays theIP address or the primary IP address of the source interface.z If neither source IP address nor source interface is specified, 0.0.0.0 is displayed. That is, as longas there is a route between the switch and client, the client can log in to the switch using the IPaddress of any Layer 3 interface on the switch.When you use the display telnet-server source-ip command to display the source IP address, theprimary IP address of an interface will be displayed even if you have specified a secondary IP addressof the interface as the source IP address.
