1-38[aaa_0.Sysname-cluster] logging-host 10.10.10.9management-vlanSyntaxmanagement-vlan vlan-idundo management-vlanViewSystem viewParametersvlan-id: ID of the VLAN to be specified as the management VLAN.DescriptionUse the management-vlan command to specify the management VLAN on the switch.Use the undo management-vlan command to restore the default management VLAN.By default, VLAN 1 is used as the management VLAN.When specifying the management VLAN, note that:z The management VLANs on all the devices in a cluster must be the same.z You can specify the management VLAN on a device only when no cluster is created on the device.You cannot change the management VLAN on a device that already joins a cluster. If you want tochange the management VLAN on a device where a cluster has already been created, you mustfirst remove the cluster configuration on the device, then re-specify a VLAN as the managementVLAN, and finally re-created the cluster.z The management VLAN of a cluster defaults to VLAN 1. To isolate cluster management packetsfrom other packets to improve the cluster information security, it is recommended to configure themanagement VLAN of the cluster as another VLAN.Examples# Specify VLAN 2 as the management VLAN of the current switch. system-viewSystem View: return to User View with Ctrl+Z.[Sysname] management-vlan 2management-vlan synchronization enableSyntaxmanagement-vlan synchronization enableundo management-vlan synchronization enableViewCluster view
