1-9Parametersunit unit-id: Specifies the unit ID of a switch. With this keyword-argument combination specified, thiscommand can display the startup configuration file information of the specified unit.DescriptionUse the display startup command to display the startup configuration of a switch.Note that:z If the switch is not a unit of a fabric, this command displays the startup configuration file informationof the current switch no matter whether you have specified the unit-id argument or not.z If the switch is a unit of a fabric, without unit-id specified, this command displays the startupconfiguration file information of all the units in the fabric; with unit-id specified, this commanddisplays the startup configuration file information of the specified unit.Related commands: startup saved-configuration.Examples# Display the startup configuration file information of the current switch, which is not in any fabric. display startupUNIT1:Current Startup saved-configuration file: flash:/config.cfgNext main startup saved-configuration file: flash:/config.cfgNext backup startup saved-configuration file: flash:/backup.cfgBootrom-access enable state: enabledTable 1-2 Description on the fields of the display startup commandField DescriptionCurrent Startupsaved-configuration file The configuration file used for the current startupNext main startupsaved-configuration file The main configuration file used for the next startupNext backup startupsaved-configuration file The backup configuration file used for the next startupBootrom-access enable stateWhether you can use the user-defined password to access theBoot ROM:z enabled indicates you can access the Boot ROM with theuser-defined password.z disabled indicates you cannot access the Boot ROM with theuser-defined password.For related information, refer to the startup bootrom-accessenable command in the File System Management part of themanual.display thisSyntaxdisplay this [ by-linenum ]
