2-18DescriptionUse the multicast static-group vlan command to configure the current port as a static member port forthe specified multicast group and specify the VLAN the port belongs to.Use the undo multicast static-group vlan command to remove the current port in the specified VLANas a static member port for the specified multicast group.By default, no port is configured as a static multicast group member port.Note that:The impact of the configuration depends on whether the current port belongs to a multicast VLAN andwhether the port belongs to the specified VLAN.z If the current port belongs to neither a multicast VLAN nor the specified VLAN, the configurationdoes not take effect.z If the current port does not belong to any multicast VLAN but it belongs to the specified VLAN, theconfiguration takes effect in the specified VLAN.z If the current port belongs to a multicast VLAN, the configuration takes effect only in the multicastVLAN no matter the port belongs to the specified VLAN or not.The port configured with this command handles Layer 2 multicast traffic only, rather than Layer 3multicast traffic.Examples# Configure port Ethernet1/0/1 in VLAN 2 as a static member port for multicast group 225.0.0.1. system-viewSystem View: return to User View with Ctrl+Z.[Sysname]interface Ethernet 1/0/1[Sysname-Ethernet1/0/1] multicast static-group 225.0.0.1 vlan 2multicast static-router-portSyntaxmulticast static-router-port interface-type interface-numberundo multicast static-router-port interface-type interface-numberViewVLAN viewParametersinterface-type interface-number: Specifies a port by its type and number.
