1-11Parametersname: MST region name to be set for the switch, a string of 1 to 32 characters.DescriptionUse the region-name command to set an MST region name for a switch.Use the undo region-name command to restore the MST region name to the default value.The default MST region name of a switch is its MAC address.MST region name, along with VLAN-to-instance mapping table and MSTP revision level, determinesthe MST region which a switch belongs to.Related commands: instance, revision-level, check region-configuration, vlan-mapping modulo,active region-configuration.Examples# Set the MST region name of the switch to hello. system-viewSystem View: return to User View with Ctrl+Z.[Sysname] stp region-configuration[Sysname-mst-region] region-name helloreset stpSyntaxreset stp [ interface interface-list ]ViewUser viewParametersinterface-list: Ethernet port list. You can specify multiple Ethernet ports by providing this argument in theform of interface-list = { interface-type interface-number [ to interface-type interface-number ] } &<1-10>,where &<1-10> means that you can provide up to 10 port indexes/port index ranges for this argument.DescriptionUse the reset stp command to clear spanning tree statistics.The spanning tree statistics includes the numbers of TCN BPDUs, configuration BPDUs, RST BPDUs,and MST BPDUs sent/received through one or more specified ports or all ports (note that BPDUs andTCN BPDUs are counted only for CISTs.)Note that:z If you specify the interface-list argument, this command clears the spanning tree statistics onspecified ports.z If you do not specify the interface-list argument, this command clears the spanning tree statisticson all ports.Related commands: display stp.
