ABB OmniCore E10 Product Manual

ConnectorsConnectors on E line controllersWAN1 WAN2 MGMTDEVICEABB Ability™ HMI4 3 2 6 7xx2100002083DescriptionE line controller labelConnected to the controller's Private Net-work. Intended for connecting ABB ScalableI/O units and network based process equip-ment local to the controller.DEVICE2Intended for connecting the controller to in-ternet/ABB Ability™.WAN 23Connected to the controller's Public Network.Intended for connecting the robot controllerto a factory wide industrial network.WAN 14Connected to the controller's Private Net-work. The MGMT port shall be used by ser-vice personnel in close proximity to the con-troller, with a single client connected to thecontroller.NoteThe management port shall never be usedfor more than one client at a time. ABB Robot-ics assumes no responsibility for any er-rors/hazards that may appear when morethan one client is used.MGMT (Management)6Specific connector for connecting the Flex-Pendant.HMI (FlexPendant)7Industrial networksConnection of industrial networksA factory wide I/O network should be connected to the WAN1 port on the controller.NoteIt is not supported to connect multiple ports of the OmniCore controller to thesame external switch unless static VLAN isolation is applied on the externalswitch.NotePrivate Network segments of multiple controllers cannot be connected to eachother.Continues on next page80 Product manual - OmniCore E103HAC079399-001 Revision: C© Copyright 2019-2022 ABB. All rights reserved.3 Installation and commissioning3.5.7 Ethernet networks on OmniCoreContinued