Name Values (Range) Unit Step Default DescriptionTypNo7 AbsoluteRelative- - Absolute Type identification (TYP)TypNo8 AbsoluteRelative- - Absolute Type identification (TYP)GiNo1 ExcludedIncluded- - Included Response and status change (GI)GiNo2 ExcludedIncluded- - Included Response and status change (GI)GiNo3 ExcludedIncluded- - Included Response and status change (GI)GiNo4 ExcludedIncluded- - Included Response and status change (GI)GiNo5 ExcludedIncluded- - Included Response and status change (GI)GiNo6 ExcludedIncluded- - Included Response and status change (GI)GiNo7 ExcludedIncluded- - Included Response and status change (GI)GiNo8 ExcludedIncluded- - Included Response and status change (GI)The FunctionType parameter associates a particular instance of the function blockwith a FUN. Refer to the IEC 60870-5-103 standard for details.The InfNon parameters are used to associate each individual input signal with auserdefined INF. Refer to the IEC 60870-5-103 standard for details.The TypNon parameters determine if messages use absolute or relative time. Thisadheres to the TYPE IDENTIFICATION (TYP) message types 1 (time-taggedmessage) and 2 (time-tagged message with relative time) of the IEC 60870-5-103standard.The GiNon parameters determine whether a message is sent as a part of a GI reply ornot. Refer to the IEC 60870-5-103 standard for details.18.6.10 Function commands for IEC 60870-5-103 I103CMD18.6.10.1 FunctionalityI103CMD is a command function block in control direction with pre-defined outputsignals. The signals are in steady state, not pulsed, and stored in the IED in case ofrestart.1MRK502052-UEN B Section 18Station communication1043Technical manual
