Chapter 77-53Mount the blade by reversing the steps used to remove it.1) Push the blade mounting base against the developing assembly, andtighten the two mounting screws.When mounting the blade, place paper on the developing cylinder firstto protect the developing cylinder.7.10.15 Transfer/Separation Charging Assembly7.10.15.1 Removing the Transfer/Separation ChargingAssembly0009-56311) Turn the fixing feeder assembly release lever [1] in the direction ofthe arrow (left) to release the transfer/separation charging assembly.Slide out the fixing feeder unit [2] to the front.F-7-1852) Detach the feeder assembly front cover (Right) [2] using the twoscrews [1].F-7-1863) Remove the screw [1] and the fixture [2], and then remove theconnector [3].F-7-1874) Pushing the front and the rear of the transfer/separation chargingassembly, pull out the assembly to the front and remove it in thedirection of upper left.F-7-188Be aware not to cut the nylon wire by coming into contact the transfer/separation charging assembly to the transfer guide.7.10.15.2 Mounting the Transfer/Separation ChargingAssembly0009-5633Mount the transfer/separation charging assembly by reversing the stepsused to remove it while keeping the following in mind.1) Make sure that the four protrusions [1] on the transfer/separationcharging assembly are correctly fitted into the cut-offs [2] in thefixing/feeding unit.2) Make sure that the leaf spring [3] of the fixing/feeding unit comes incontact with the frame of the transfer/separation charging assembly(slide from the front).F-7-189[1] [2][1][1][2][1][2][3]12[1][1] [1][1]
