Chapter 1313-1813.2 Image Adjustments13.2.1 Standards of Image Position0008-7917The image margin/non-image width of a print made in direct must be asfollows:mage Leading Edge MarginF-13-17Left/Right Image MarginF-13-18Leading Edge Non-Image WidthF-13-19Left/Right Non-Image WidthF-13-2013.2.2 Checking the Image Position0008-7918Make prints using the following as the source of paper (10 prints each),and check to see that the image margin and the non-image width are asindicated:- Each cassette- Front deck (left, right)- Manual feed tray- Duplex feeding unit- Side paper deckIf not as indicated, adjust the image position in the following order:1. Adjusting the left/right image margin (registration)2. Adjusting the image leading edge margin (registration)3. Adjusting the left/right non-image width (CCD read start position)4. Leading edge non-image width (scanner image leading edge position)13.2.3 Adjusting Side Registration0009-45931) Press the release button to draw out the cassette 3/4.2) Loosen the 2 fixing screws [1] on both sides of the cassette.3) Move the cassette body frontward or backward to adjust.Backward: The side registration value (left margin) is decreased.Frontward: The side registration value (left margin) is increased.F-13-214) Make sure that the side registration values (left margins) of a copymade from the cassette 3/4 are L1 = 2.5±1.5mm respectively.F-13-22[1] Paper feed direction5) Tighten back the 2 fixing screws [1] after the adjustment.F-13-236) Put back the cassette 3/4 to the machine.7) Perform the following service mode after the adjustment.Cassette 31.5mm1.0mm4.02.5 1.5mm02468101.5mm1.0mm4.02.5 1.5mm0246810[1][2][1][2]imageL1[1][1]
