Chapter 88-368.10 Parts Replacement Procedure8.10.1 Pickup Roller8.10.1.1 Removing the Right Deck/ Cassette PickupAssembly0009-5104The removal procedure of a right door and a left door is the same. Anillustration makes a right door an example and explains it.1) Slide out the right deck / cassette3 / cassette4.2) Open the right upper cover and the right lower cover.An attempt to remove the pickup assembly without removing the deckwill cause the lifter to get trapped, not holding the pickup assembly fromsliding out.3) Remove the mounting screw [1], and detach the connector cover [2];then, disconnect the connector [3].4) Remove the three mounting screws [4], and detach the pickupassembly [5].F-8-528.10.1.2 Removing the Left Deck Pickup Assembly0009-51101) Slide out the left deck.2) Remove the two screws [1] found on the left and right sides of the leftdeck[2]; then, detach the left deck[2].F-8-533) Open the front cover.4) Disconnect the connector [1] from inside the machine, and removethe locking support [2].F-8-545) Remove the two screws [1], and detach the two pickup fixing plates[2]; then, detach the left deck pickup assembly [3].Keep supporting the pickup assembly; otherwise, the pickup assemblycould drop when the fixing plate is removed.F-8-558.10.1.3 Removing the Pickup Roller0009-51051) Remove the two resin E-rings [1] on the outside, and detach thepickup roller [2] in the direction of the arrow.F-8-568.10.1.4 Orientation of the Deck/Cassette Pickup Roller0009-5106The pickup roller may be mounted by reversing the steps used to removeit; however, be sure to keep the following in mind:- The pickup rollers used at the front and the rear of the machine are notinterchangeable.[3][4][4][5][1][2][1][1][2][2][1][3][1][1][2] [1][1][2]
