Chapter 1616-43ORG-LTR Use it to set a special paper size that the ADF cannot recognize (applicable toLTR communicated by the ADF).setting0: LTR (default)1: G-LTR2: A-LTR3: EXECTIVE2ORG-LTRR Use it to set a special paper size that the ADF cannot recognize (applicable toLTR-R communicated by the ADF).setting0: LTR-R (default)1: G-LTR-R2: A-LTR-R3: EXECTIVE-R2ORG-B5 Select a special paper size that the ADF cannot recognize (applicable to B5communicated by the ADF).setting0: B5 (default)1: K-LEGAL2UI-BOX Use it to enable/disable the display of the box screen on the control panel.setting0: do not display1: display (default)2: do not display (however, permit storage of PDF job in box)2UI-SEND Use it to enable/disable display of the transmission screen on the controlpanel.setting0: do not display1: display (default)2UI-FAX Use it to enable/disable display of the fax screen on the control panel.setting0: do not display1: display (default)2UI-EXT Use it to enable/disable display of the expansion screen on the control panel.setting0: do not display1: display (default)2NW-SPEED Use it to select the appropriate data transmission speed when a connector ismade to a service network.setting0: auto (default)1: 100Base-Tx2: 10Base-T2STS-PORT Use it to enable/disable the port for TOT synchronous commandcommunications.setting0: disable (off; default)1: enable (on)2CMD-PORT Use it to enable/disable the port for TOT asynchronous statuscommunications.Use it to enable/disable the port for asynchronous status communicationswhen FTUIF-over-TCP/IP is in use.setting0: disable (off; default)1: enable (on)2MODELSZ2 Use it to enable/disable platen board original size detection (for globalsupport; AB/inch mix).setting0: disable global detection (default)1: enable global detection2SZDT-SW Use it to enable/disable switchover of CCD size detection and photo sizedetection for platen board original size detection.setting0: disable photo size detection1: enable photo size detection2NS-CMD5 Use it to limit the use of CRAM-MD5 authentication for SMTPauthentication.Use it to put limits to the use of CRAM-MD5 authentication for SMTPauthentication.setting0: as determined by SMTP server (default)1: do not use2NS-GSAPI Use it to limit the use of GSSAPI authentication for restrictive SMTPauthentication as part of GSSAPI authentication of SMTP authentication.setting0: as determined by SMTP server (default)1: do not use2COPIER > OPTION > BODYSub-item Description Level
