Chapter 1616-42SENS-CNF Use it to set the arrangement of original sensors.setting0: AB (default)1: inch2: A2RAW-DATA Use it to specify how received data should be printed.If a received image has a fault, use this mode to find out if the fault is in thedata or in image processing.setting0: normal operation (default)1: print as is2SHARP Use it to change the level of sharpness (median value).setting: 1 to 5 2LAPC-SW Use it to switch over laser APC correction.0: execute initial rotation APC if left alone for 10 min1: execute initial rotation APC if left alone for 60 min (default)2: execute initial rotation if left alone for 120 min3: disable initial rotation APC only4: disable2FDW-DLV Use it to select face-up delivery or face-down delivery when the count is setto multiple.setting0: normal (for a single original, face-up for all; default)1: for a single original, face-up delivery if the count is set to '1'; otherwise,face-down2COTDPC-D This item is for use at the factory.setting: 0 to 3 (default: 0) 2EVL-VDT Use it to switch over drum target potential to suit the environment of the site.setting: 0 to 6 (default: 1) 2RMT-LANG Use it to change the language for the remote UI to be used through the Webbrowser.Select the particular language using the + and - keys.2HI-HUME Use it to change the developing bias frequency.If a separation fault occurs in a high humidity environment, set it to '1'.setting0: 2700 Hz (default); 1: 200 Hz2IFAX-LIM Use it to limit the number of output lines if an excess volume of data isreceived through i-fax.setting: 0 to 999 (default: 500)0: no limit2DF-BLINE Use it execute a remedial measure in response to black lines caused by duston the platen roller when the ADF is use (stream reading mode).setting0: disable (default)1: enable2DRM-H-SW Use it to enable/disable the nighttime drum heater.0: enable drum heater1: turn on/off drum heater in keeping with environment (default)2: disable drum heater2SMTPTXPN Use it to change the SMTP transmission port number.setting: 0 to 65535 2SMTPRXPN Use it to change the SMTP transmission port number.setting: 0 to 65535 2POP3PN Use it to change the POP reception port number.setting: 0 to 65535 2RUI-DSP Use it to enable/disable a remote IU function (designed for the DisabilitiesAct).setting0: do not show Copier screen on remote UI (default)1: show Copier screen2ORG-LGL Use it set a special paper size that the ADF cannot recognize (applicable toLGL communicated by the ADF).setting0: LGL (default)1: FOOLSCAP2: A-FOOLSCAP3: FORIO4: G-LEGAL5: OFFICIO6: E-OFFICIO7: A-OFFICIO8: B-OFFICIO9: A-LEGAL10: M-OFFICIO2COPIER > OPTION > BODYSub-item Description Level
