Chapter 11-22If your skin or clothes have come into contact with toner, remove as much toner as possible using dry paper tissue, and wash with water. Do not use warmor hot waster; otherwise, the toner will jell and fuse permanently with the fibers of the clothes. Also, do not bring toner into contact with vinyl, as it tendsto react.Do not throw toner into fire. An explosion can occur.1.2.6 Product Specifications1.2.6.1 Product Specifications0008-8570Copyboard stream reading, fixed readingBody consoleLight source type xenon lamp (yellow green)Lens type fixed focusPhotosensitive medium A-Si drum (80-mm dia.)Image reading method light-receiving element (1 line CCD)Reproduction method indirect electrostaticExposure method laser lightCopy density adjustmentfunctionauto or manualCharging method coronaDevelopment method dry, 1-component toner projectionTransfer method corona / postSeparation method static separationPickup method from cassette, manual feeder, paper deckCassette pickup method separation retardPaper deck pickup method separation retardMultifeeder pickup method separation retardDrum cleaning method blade + magnet rollerFixing method heat roller (IH heater)Delivery method face-down, face-upToner level detectionfunctionyesToner type Magnetic, positive tonerToner supply type toner bottleOriginal type sheet, book, 3-D object (2 kg max.)Maximum original size 297mm x 431.8mmOriginal size detectionfunctionfixed sensor in combination with CCDReproduction ratio 100% (1:1), reduce (1:0.250, 1:0.500, 1:0.611, 1:0.707,1:0.816, 1:0.865), enlarge (1:1.154, 1:1.224, 1:1.414, 1:2.000,1:4.000), between (1:0.250 to 4.000) (25% and 400%, in 1%-increments)Warm-up time 30sec or lessMaximum non-image width(main scanning direction)2mm or lessMaximum non-image width(sub scanning direction)2mm or lessImage margin (leading edge) 4.0+1.5/-1.0mmImage margin (trailing edge) 2.0±1.5mmImage margin (left/right) left: 2.5±1.5mm (2nd side: 2.5±2.0mm), right: 0.5mm or moreNon-image width (leadingedge)4.0+1.5/-1.0mm (w/ ADF: 4.5±1.8mm)Non-image width (trailingedge)2.0±1.5mm (W/ ADF: 2.0±1.8mm)
