Chapter 99-10T-9-6SERVICE MODE:COPIER>OPTION>BODY>FSPD-S1 (Category 2)Use it to select enhanced fixing mode:0: normal (default)1: enhanced fixing mode2: not usedMEMO:If both enhanced fixing mode and heavy paper mode (or, transparency mode) are selected at the same time, heavy paper mode (transparency mode) willbe given priority.9.2.12 Heavy Paper Mode0009-4222The machine increases fixing temperature and changes the copying/printing speed to ensure fixing on heavy paper.A cassette for which heavy paper has been selected is used as the source of paper.- The target temperature differs depending on the environment temperature:if the environment temperature is 17 deg C or higher,-> +12 deg C in relation to the target temperature.if the environment temperature is lower than 17 deg C,-> 217 deg C.- The machine starts to feed paper when the reading of the main thermistor becomes identical to the target temperature.- The copying/printing speed is as follows:pickup from the cassette-> 55 cpm/ppmpickup from the manual feeder-> 44 cpm/ppm- If the environment temperature is lower than 17 deg C, the machine decreases the target temperature by 5 deg C every 3 min after paper feed (to as lowas 192 deg C).- If the environment temperature is 17 deg C or higher, the machine decreases the target temperature by 5 deg C every 1 min after paper feed (to as low as192 deg C).- If the environment temperature is less than 17 deg C, the machine executes idle rotation of the fixing roller for 1 min (to collect heat in the fixing assembly)before starting copying/printing operation.- If heavy paper exists together with plain paper for output, the machine holds paper at the point of registration until the target temperature for heavy paperis reached.- If plain paper is picked up while the machine is in heavy paper mode, the machine will use the target temperature for heavy paper for fixing.9.2.13 Transparency Mode0009-4223The machine increases the fixing temperature to ensure good fixing on transparencies.- The paper type is identified as being "transparency" for the manual feed tray while the tray is used as the source of paper.The target temperature of the fixing roller is 217 deg C.- The machine starts paper feed d when the reading of the main thermistor becomes identical to the target temperature.at power-on target temperature forstandby modestart-up sequence time used (ref.)normal mode if the temperature of theenvironment is 17 deg Cor higher30-sec start-up mode,or high humidityenvironment start-upmode60 sec (in highhumidityenvironment start-up mode)See descriptions under"Standby Mode."if the temperature of theenvironment is lowerthan 17 deg Clow temperatureenvironment start-upmode75 sec or lessfixingenhancementmodeif the temperature of theenvironment is 17 deg Cor higherhigh humidityenvironment start-upmode60 sec normal standby mode +10 deg Cif the temperature of theenvironment is lowerthan 17 deg Clow temperatureenvironment start-upmode120 sec or less same as normal mode
