Chapter 1616-4016.6 OPTION (Machine Settings Mode)16.6.1 COPIER16.6.1.1 COPIER List0009-6265T-16-51COPIER > OPTION > BODYSub-item Description LevelPO-CNT Use it to turn on and off the potential control mechanisms.setting: 0: off; 1: on (default) 1MODEL-SZ Use it to switchover the default magnification ratios and ADF original sizedetection.0: AB (6R5E)1: inch (5R4E)2: A (3R3E)3: AB/inch (6R5E)1FIX-TEMP Use it to select down sequence mode.0: normal (default)1: standard + 10 deg C2: standard - 5 deg C1FUZZY Use it to turn on and off fuzzy control and to set the environment.0: enable fuzzy control (default)1: fix to low humidity environment mode (current level lower than standard)2: fix to normal temperature/humidity mode3: fix to high humidity mode (current level higher than standard)1CONFIG Use it to select multiple firmware items stored on the hard disk andswitchover country, language, machine type, and paper size configuration.ProcedureXXYYZZXX: country (JP); YY: language (ja); ZZ (00): machine type; AA (00): papersize configuration. The indications will be in keeping with the following:COPIER>DISPLAY>USER>LANGUAGE.(The notations in parentheses indicate defaults. The country and languagenotations are for indication only.)1) Select .2) Select the appropriate item to highlight, and press the +/- key.3) See that each press on the +/- key changes the selections in sequence.4) When you have made all selections, press the OK key.5) Turn off and then on the main power switch.1TR_SP_C1 Use it to change the transfer/separation output settings when the right deck isused as the source of paper by way of providing a remedial measure.Setting0: normal (default); 1: double transfer; 2: separation fault; 3: transfer fault1TR_SP_C2 Use it to change the transfer/separation output setting when the left deck isused as the source of paper by way of providing a remedial measure.Setting0: normal (default); 1: double transfer; 2: separation fault; 3: transfer fault1TR_SP_C3 Use it to change the transfer/separation output setting when the cassette 3 isused as the source of paper by way of providing a remedial measure.0: normal (default); 1: double transfer; 2: separation fault; 3: transfer fault1TR_SP_C4 Use it to change the transfer/separation output setting when the cassette 4 isused as the source of paper by way of providing a remedial measure.0: normal (default); 1: double transfer; 2: separation fault; 3: transfer fault1TR_SP_MF Use it to change the transfer/separation output setting when the manual feedtray is used as the source of paper by way of providing a remedial measure.Setting0: normal (default); 1: double transfer; 2: separation fault; 3: transfer fault1TR_SP_DK Use it to change the transfer/separation output setting when the side paperdeck is used as the source of paper by way of providing a remedial measure.Setting0: normal (default); 1: double transfer; 2: separation fault; 3; transfer default1W/SCNR Use it to indicate the presence/absence of a reader unit.0: reader unit absent (printer model)1: reader unit present (default)When the presence of a reader unit is detected, the machine will automaticallyset it to '1'.1
