Chapter 99-11- the copying/printing speed is 44 cpm/ppm.- if the environment temperature is lower than 17 deg C, the machine starts output 1 min after the end of start-up mode (executes initial rotation for 1 min).- If a transparency exists among plain paper for output, the machine will hold the paper at the point of registration until the target temperature is reached.- If plain paper is picked up while the machine is in transparency mode, the machine will continue to use the target temperature for transparencies for fixing.If a transparency tends to wrap around the fixing roller when the machine is in transparency mode, you can improve separation by decreasing the fixingtarget temperature for transparency mode using the following service mode item:SERVICE MODE:COPIER>OPTION>BODY>OHP-TEMP (Category 2)0: normal (default)1: -5 deg C2: -10 deg C3: -15 deg C4: -20 deg C9.2.14 Bond Paper Mode0009-4224The machine increases the fixing temperature while decreasing the copying/printing speed in a low-temperature environment to ensure fixing on bondpaper.A cassette selected for bond paper is used as the source of paper.- if the environment temperature is 17 deg C or higher,the target temperature is 205 deg C (same as normal copying/printing mode)- if the environment temperature is lower than 17 deg C,the target temperature is 210 deg C- the copying/printing speed is 30 cpm/ppm
