Chapter 1616-188LDAP-DEF Switch the default setting of the LDAP searching condition.Change the default setting of a searching attribute condition specified for LDAP searching.1Setting range0 to 60: "Name"1: "E-mail"2: "FAX"3: "Organization"4: "Unit of organization"5: User setting 16: User setting 2Standard value0Refer to COPIER > OPTION> USER > LDAP-SW for the details of LDAP.DK3-ASST Switch the air heater control for the pickup deck with air-assist function. (Setting for PDO deckLite)Switch the condition to turn on the air heater for air-assist function according to the media andenvironment.1Setting range0: Control the air heater based on the media and environment condition.1: Turn on the air heater based on the environment condition only. (Not dependent on the media)2: Turn on the air heater constantly. (Not dependent on the environment and media)Standard value0RemarksWhen switching the media setting from non-coated paper to coated paper for the pickup deck withair-assist function, wait-time occurs before the temperature of the air heater is controlled. (Forcoated paper, pickup cannot be performed until the air heater is turned on and warm air blows.)Furthermore, when the machine is used in the environment near the ON/OFF switching condition,it is assumed that the ON/OFF switching of the air heater is frequently performed and it increasesthe wait-time.When you receive a claim from a user that the wait-time is too long, perform the followingmeasures;- For the former case (switching of the media setting from non-coated paper to coated paper),explain that transfer performance of noFX-BC-SW Set ON/OFF of the wait-mode control for cooling of the fixing assembly.1Setting rangeOFF [0] / ON [1]Standard value0CARD-DIR 4-pane postcard feeding direction settingSet the feeding direction of 4-pane postcard.1Setting range: 0 to 10: Short edge feed only1: Available to switch Long edge feed/Short edge feed.Standard value 0This item applies to the upgraded device or later (DCON Ver11.03 or later, Cont Ver24.04 orlater)SIZE-DET Set ON/OFF of the document size detection function.2Setting range0: OFF (This eliminates glare because the optical system does not light up when the copyboard isopened/closed.)1: ONStandard value1COPIER>OPTION>USERSubheading Contents Level
