Chapter 1313-8F-13-1713.4.2 After Replacing the Fixing Roller 0013-3398imagePRESS C1 P / imagePRESS C1 / imagePRESS C1+ (Printer) / image-PRESS C1+- Apply approx. 20 mg of grease (Molykote HP-300; CK-8012) to the bush-ing inner periphery [1] and external periphery [2] so as to make whitecoating on all the area.Purpose: Prevent noise (rasping sound).F-13-18- The grease is attached on the end of the fixing roller [1] when fixing thegreased bushing with the fixing roller, so wipe it off.F-13-1913.4.3 After Replacing the Fixing Belt 0013-3404imagePRESS C1 P / imagePRESS C1 / imagePRESS C1+ (Printer) / image-PRESS C1+Before installing a new belt, apply silicon oil (S-20; FY9-6011) to themarked area of the pressure pad cover (within the radius of about 200 mmfrom the center).Apply silicon oil to the pressure pad cover, after soaking lint-free paper intothe oil to the extent that the oil does not drip from the paper.F-13-20[1] pressure pad cover13.4.4 After Replacing the Fixing Cleaning Belt 0013-3403imagePRESS C1 P / imagePRESS C1 / imagePRESS C1+ (Printer) / image-PRESS C1+Set the value clear '0' for the following service counters.- COPIER> COUNTER> DRBL-1> FX-WEB13.4.5 After Replacing the Fixing Belt / Pressure PadCover 0014-6124imagePRESS C1 P / imagePRESS C1 / imagePRESS C1+ (Printer) / image-PRESS C1+Before installing a belt, apply silicon oil (S-20; FY9-6011) to the markedarea of the pressure pad cover (within the radius of about 200 mm from thecenter).Apply silicon oil to the pressure pad cover, after soaking lint-free paper intothe oil to the extent that the oil does not drip from the paper.F-13-21[1] pressure pad cover13.4.6 When replacing pressure belt 0020-8935imagePRESS C1 P / imagePRESS C1 / imagePRESS C1 (CUSTOM) / im-agePRESS C1+ (Printer) / imagePRESS C1+1) Apply silicone oil to the following areas:- Surface of oil coating roller: 0.1ml- Surface of inlet roller: 0.1ml[Tools to be used]- Silicone oil (Parts Number: FY9-6011)- Dropper1-1) Make a paper slip to be used for applying the oil. Cut A4 paper into 1/8(approx.), and then fold the piece into three.1-2) While turning the oil coating roller, apply 0.1ml of silicone oil at thecenter [1] (30mm inside from the both ends) on the surface of the rollerAB20mm150mm[2][1][1][1][1]
