Chapter 1616-278DK3-ASST Switch the air heater control for the pickup deck with air-assist function. (Setting for PDO deckLite)Switch the condition to turn on the air heater for air-assist function according to the media andenvironment.1Setting range0: Control the air heater based on the media and environment condition.1: Turn on the air heater based on the environment condition only. (Not dependent on the media)2: Turn on the air heater constantly. (Not dependent on the environment and media)Standard value: 0RemarksWhen switching the media setting from non-coated paper to coated paper for the pickup deck withair-assist function, wait-time occurs before the temperature of the air heater is controlled. (Forcoated paper, pickup cannot be performed until the air heater is turned on and warm air blows.)Furthermore, when the machine is used in the environment near the ON/OFF switching condition,it is assumed that the ON/OFF switching of the air heater is frequently performed and it increasesthe wait-time.When you receive a claim from a user that the wait-time is too long, perform the followingmeasures;- For the former case (switching from the non-coated paper to coat paper), explain that there issome worry that the transformation of non-coat paper will deteriorate, switch to 1, even for thenon-coat paper, depending on the environment condition, the Air Heat can switch to On.- The later case, (if the machine is used in the environment near ON/OFF switching), when thetemperature gets lower, explain that there is some worry that the transformation of non-coat paperwill deteriorate, switch to 2, regardless to media and environment, the Air Heat can always switchto On.Steps of Operation :0. Check, depends on the media and environment, the Air Heater is switched to ON.1. Check, only by the environment condition that the Air Heater is switched to ON.2. Check, that the Air Heater is always switched to ON.FX-BC-SW Set ON/OFF of the wait-mode control for cooling of the fixing assembly.1Setting range: OFF [0] / ON [1]Standard value: 0CARD-DIR 4-pane postcard feeding direction settingSet the feeding direction of 4-pane postcard.1Setting range: 0 to 10: Short edge feed only1: Available to switch Long edge feed/Short edge feed.Standard value: 0This item applies to the upgraded device or later (DCON Ver11.03 or later, Cont Ver24.04 orlater)SIZE-DET Set ON/OFF of the document size detection function.2Setting range0: OFF (This eliminates glare because the optical system does not light up when the copyboard isopened/closed.)1: ONStandard value: 1DATE-DSP Switch the date display.2Setting range:0: YYMM/DD1: DD/MM'YY2: MM/DD/YYMB-CCV Restrict the use of the control card for mailbox.2Setting range0: Do not restrict the use.1: Restrict the use.Standard value: 0TRY-STP Set a mode not to perform printing when the tray is full.2Setting range0: Normal mode (Stop printing when the finisher tray is full.)1: Stop printing only by detecting the height.Standard value: 0MF-LG-ST Set a key for the long length paper mode.2Setting range0: Normal1: Display the long length key in the corresponding mode screen.Standard value: 0CNT-DISP Set whether or not to display a serial number when pressing the counter check key.2Setting range0: Display a serial number.1: Do not display a serial number.Standard value: 0COPIER > OPTION > USERSubheading Contents Level
