Chapter 77-63The secondary transfer static eliminator bias reduces the charge on the back of the print paper to weaken electrostatic absorption of the paper, enabling easyseparation.- Splash toner collecting bias (applied bias: -DC)In the splash toner collecting bias, the high-voltage is applied on the toner-blocking terminal plate beneath the developing cylinder to attract the suspendedtoner and prevent toner splash in the machine.7.9.3 Overview of the Primary Transfer Assembly 0013-6761imagePRESS C1 P / imagePRESS C1 / imagePRESS C1+ (Printer) / imagePRESS C1+The primary transfer assembly has three motors to activate/detach the main roller.The drum/ITB motor (M2) rotates the ITB drive roller and the ITB cleaning screw. The brush roller attachment/detachment motor (M18) performs attachment/detachment between the brush roller for ITB cleaning and the ITB. The brush roller drive motor (M26) activates the brush roller to collect the residual toner on theITB.The DC controller performs drive/detachment by controlling three motors via the side driver PCB.The DC controller performs ITB cleaner attachment/detachment detection to detect the position of the brush roller for ITB cleaning via the side driver PCB.F-7-78[1] ITB drive roller[2] ITB cleaning screw[3] ITB cleaner[4] Brush roller[5] Bias roller[6] Cleaner blade[7] Side driver PCBPS24: Brush roller home position sensorM2: Drum/ITB motorM18: Brush roller attachment/detachment motorM26: Brush roller drive motorDC-CON: DC controller7.9.4 ITB Cleaner Attachment/Detachment Control 0013-6773imagePRESS C1 P / imagePRESS C1 / imagePRESS C1+ (Printer) / imagePRESS C1+To remove the residual toner on the ITB, this machine performs attachment/detachment between the brush roller for ITB cleaning and the ITB.The DC controller performs attachment/detachment by activating the brush roller attachment/detachment motor (M18) via the side driver PCB.The DC controller activates the brush roller by driving the brush roller drive motor (M26) via the side driver PCB.The following is the timing of attachment/detachment.1. At initial rotation or just after the start of secondary transfer, the DC controller outputs the brush roller attachment/detachment drive signal via the side driverPCB.2. The attachment/detachment arm is activated by rotating the attachment/detachment cam clockwise (See the following chart A).(thereby locking brush roller in place against ITB3. After applying pressure on the ITB, the DC controller outputs the brush roller drive motor drive signal via the side driver PCB.[7]PS24M18M26DC-CONM2[2][5]J3405J1193 J1173[1][4][3][6][6]
