Chapter 1616-8714. MISCT-16-85MF-A4 Enter the basic value of the paper width for the manual feed tray. (A4)Adjustment method- When you executed 'RAM clear' for the DC controller PCB or replaced the DC controller PCB,enter the value indicated in the service label.- When you replace the paper width detection VR or newly register a value, executeFUNCTION>CST in the Service Mode. 1Adjustment range: 0 to 255[Factory setting value / Value after RAM clear: 42]COPIER>ADJUST>MISCSubheading Contents LevelSEG-ADJAdjust the separation level for characters and photos at the character/photo/map mode.Adjustment method- To make it easier to recognize a photo document, increase the setting value.- To make it easier to recognize a character document, decrease the setting value. 1Adjustment range: -4 to 4[Factory setting value / Value after RAM clear: 0]K-ADJ Adjust the black recognition level for black character processing.Adjustment methodTo make it easier to recognize black color, increase the setting value. 1Adjustment range: -3 to 3[Factory setting value / Value after RAM clear: 0]DF-S-RK Set a characteristic value of the paper thickness sensor which was set at a factory.Since the sensor detection level varies among paper thickness detection sensors, set the sensorrank information when replacing the sensor or executing DconRAM clear.1Setting range: 1 to 5ACS-ADJ Adjust the color recognition level at ACS mode.Adjustment method- To make it easier to recognize a black and white document, increase the setting value.- To make it easier to recognize a color document, decrease the setting value. 1Adjustment range: -3 to 3[Factory setting value / Value after RAM clear: 0]WT-ER-LV Set the threshold value to display the waste toner FULL error.When the number of sheets specified by WT-ER-LV is exceeded, an error (E013) is displayed.1This mode is not used for this machine.WT-FL-LM Set the threshold value to display the waste toner FULL warning.Set the threshold value for the detection of a waste toner box error.1This mode is not used for this machine.ACS-EN Adjust the ASC judgment area.2Setting range-2 to +2[Factory setting value / Value after RAM clear: 1]ACS-CNT Set the chromatic color count area for ASC.2Adjustment range-2 to +2[Factory setting value / Value after RAM clear: 0]ACS-EN2 Adjust the ACS judgment area. (at DF stream reading)Adjustment methodWhen you increase the setting value, the judgment area becomes wider. 2Adjustment range-2 to +2[Factory setting value / Value after RAM clear: 1]COPIER>ADJUST>CST-ADJSubheading Contents Level
