Eaton SmartWire-DT SWD Series Manual

4 PKE-SWD-32, interface for motor-starter combination with PKE PKE12/324.9 ProgrammingSmartWire-DT module IP20 01/20 MN05006001Z-EN www.eaton.com 1094.9 Programming4.9.1 PKE-SWD-32 cyclical dataThe PKE-SWD-32 has a maximum of five input bytes and one output byte.4.9.1.1 Input pointsByte 0:Status information: DILM, PKE, PKE-SWD-32Byte 1:Set value I r, trip reasons, acknowledge signal￫ The number of cyclical input bytes can be adjusted by means ofdifferent data profiles of the module (￫ Section 4.9.3, "Dataprofiles", page 120).7 6 5 4 3 2 1 0SUBST PRSNT – DIAG A2 A1 P CData bit Designation Description0 C = Contactor Contactor state Contactor0: contactor not tripped1: contactor tripped1 Stat. PKE status0: PKE switched of/tripped1: PKE Powered up2 - 3 A1, A2 Position of 1-0-A switch00: Incorrect position for longer than 4 seconds01: Position A (Switching command via SWD)10: Position 0 (Contactor OFF)11: Position 1 (Contactor ON)4 DIAG 0: No diagnostic alarm1: Module signals diagnostics6 PRSNT 0: Module not available1: Module available7 SUBST 0: Configured module present1: Universal module M22-SWD-NOP(C) present7 6 5 4 3 2 1 0ACKR TRIPR TRIPR TRIPR Ir Ir Ir Ir