Eaton SmartWire-DT SWD Series Manual

6 PKE-SWD-CP, Connection for circuit-breaker PKE6.10 ProgrammingSmartWire-DT module IP20 01/20 MN05006001Z-EN www.eaton.com 147Byte 6:Byte 7:6.10.1.2 OutputsByte 0:If remote tripping is enabled with the R-TRIP output bit, there will be a trip ifthe trip block phase currents exceed the values specified below:6.10.1.3 DiagnosticsIn the event of a diagnosis the module reports the following error causes(input byte 0, bit 4 is set):7 6 5 4 3 2 1 0I-REL-L2 I-REL-L2 I-REL-L2 I-REL-L2 I-REL-L2 I-REL-L2 I-REL-L2 I-REL-L2Data bit Designation Description Notes0 - 2 I-REL-L2 Relative phase current L2 ￫ Section 6.10.1.6, „Relative currentvalue (I-REL)“, page 1497 6 5 4 3 2 1 0I-REL-L3 I-REL-L3 I-REL-L3 I-REL-L3 I-REL-L3 I-REL-L3 I-REL-L3 I-REL-L3Data bit Designation Description Notes0 - 2 I-REL-L3 Relative phase current L3 ￫ Section 6.10.1.6, „Relative currentvalue (I-REL)“, page 1497 6 5 4 3 2 1 0– – – – – – R-TRIP –Data bit Designation Description Notes0 – Not used1 R-TRIP Remote tripping, PKE basic device0: no remote tripping1: Remote tripping2-7 – Not usedPKE-XTU(W)ACP-36 PKE-XTUACP-65single-phase15 A 30Atwo-phase 12A 24Athree-phase 8A 16A