Eaton SmartWire-DT SWD Series Manual

11 Interface for NZM compact circuit-breakers11.8 ProgrammingSmartWire-DT module IP20 01/20 MN05006001Z-EN www.eaton.com 23711.8.1.4 Currents: profile 2Profile 2 contains the digital status data as well as the phase currents thatthe table shows.1)• With a Motorola-based GSD (Moel4d14.gsd), the currents are stated in the order High byte, Low byte,• With an Intel-based GSD (Moe4d14.gsd) the currents are stated as word values.• Current values are measured from I > 0.2 × I n . At smaller currents the value is zero.11.8.1.5 Energy values: profile 3In addition to the data of profile 2, profile 3 contains the energy valuesshown in the table.11.8.1.6 Actual parameters and circuit-breaker data: profile 4Profile 4 contains the digital status data, the phase currents, the energy val-ues as well as the circuit-breaker data with the currently set values.Byte Bit Description Remark7 6 5 4 3 2 1 03 X X X X X X X X Current I1 [A] 1) RMS value4 X X X X X X X X Current I1 [A] 1)5 X X X X X X X X Current I2 [A] 1)6 X X X X X X X X Current I2 [A] 1)7 X X X X X X X X Current I3 [A] 1)8 X X X X X X X X Current I3 [A] 1)9 X X X X X X X X Current I max [A] 1) Maximum value of the three phasecurrents10 X X X X X X X X Current I max [A] 1)Byte Bit Description Remark7 6 5 4 3 2 1 011 X X X X X X X X Energy value high section S0 counter value 32 bit12 X X X X X X X X Energy value high section S0 counter value 32 bit13 X X X X X X X X Energy value low section S0 counter value 32 bit14 X X X X X X X X Energy value low section S0 counter value 32 bitByte Dec.valueDescription Remark15 0 Ir = 0.5 x In Set value for Ir15 1 Ir = 0.55 x In15 2 Ir = 0.6 x In15 3 Ir = 0.65 x In15 4 Ir = 0.7 x In15 5 Ir = 0.75 x In