Eaton SmartWire-DT SWD Series Manual

7 Pilot devices M22-SWD…7.3 M22-SWD base fixingSmartWire-DT module IP20 01/20 MN05006001Z-EN www.eaton.com 201By changing the content of bits 5 to 7, the brightness can be reduced to any of eight settings. The LEDwill continue to be switched on and off via output Q0.Table 56: Brightness settingDiagnosticsIn the event of a diagnosis the module reports the following error causes (0is set for bit 4 in the input byte):7.3.9.5 M22-SWD-K22LEDC-(W/B/G/R)The function element has one input byte and one output byte at its disposal.Input pointsByte 0:DIM2 DIM1 DIM00 0 0 Full brightness0 0 1 First dimming setting- - - ...1 1 1 Eighth dimming settingValue Description0x10 The contact is in the middle position for longer than fourseconds.0x11 Contact short-circuit7 6 5 4 3 2 1 0SUBST PRSNT – DIAG NO2 NC2numer-icalconverterNO1 NC1numer-icalconverterBit Designation Description0 NC1 = Normally Closed 0: contact 1 actuated1: contact 1 not actuated1 NO1 = Normally Open 0: contact 1 not actuated1: contact 1 actuated2 NC2 = Normally Closed 0: contact 2 actuated1: contact 2 not actuated3 NO2 = Normally Open 0: contact 2 not actuated1: contact 2 actuatedNO1NC1NO2NC2