Eaton SmartWire-DT SWD Series Manual

2 I/O modules EU5E-SWD…2.13 Analog module EU5E-SWD-2A2A54 SmartWire-DT module IP20 01/20 MN05006001Z-EN www.eaton.com2.13 Analog module EU5E-SWD-2A2A2.13.1 INTRODUCTIONSmartWire-DT I/O module EU5E-SWD-2A2A provides two analog inputs andtwo analog outputs for current.Current (0 – 20 mA) or voltage (0 – 10 V) sensors or actuators can be con-nected to the inputs/outputs.The resolution is 12 Bit.The SmartWire-DT diagnostic LED is used to signal the network's/module'sstatus.2.13.2 Surface mountingFigure 22: Layout of module EU5E-SWD-2A2A2.13.3 EngineeringThe signal range (voltage 0 – 10 V, current 0 – 20 mA) can be separately setfor each input and output. The selection is made in the programming sys-tem’s control configurator.The inputs/outputs are electrically isolated from the SmartWire-DT networkbut not from each other.The resolution is 12 Bit.The outputs are short-circuit proof.abcda SmartWire-DT cable with external device plugb SmartWire-DT diagnostics LEDc Input IA0, IA1, output QA0, QA1d 0-V-24-V connection supply￫ All 0 V connections (Ix - , Qx- ; x = 0, 1) are connected with eachother and with the module’s 0 V supply.