Eaton SmartWire-DT SWD Series Manual

3 Switching on DIL-SWD-32-001, DIL-SWD-32-002 contactors3.2 Surface mounting66 SmartWire-DT module IP20 01/20 MN05006001Z-EN www.eaton.com3.2 Surface mountingThe following diagram shows the two modules.The external device plug with an adapted SmartWire-DT connecting cable isconnected to the contactor module DIL-SWD via connection ① .The communication status and switching command via the SmartWire-DTsystem are indicated by way of a two-color diagnostics LED ③(￫ Chapter 3 “Switching on DIL-SWD-32-001, DIL-SWD-32-002 contac-tors”, page 81).As well as the communication signals a 24 V DC supply for the contactor coilis also transmitted via the SmartWire-DT connection cable. The integratedelectronics transfers the voltage to the connection pins ⑤ that are con-nected to the contactor coils.The SmartWire-DT module for DILM is connected with the contact bridge ofthe contactor with the catch slider ④. Feedback on the switching status ofthe contactor is goes into the field bus.In addition the status of the connected contactor can be acquired via theswitch position indicator ②.DIL-SWD-32-001 DIL-SWD-32-002Figure 26: Structure of the SmartWire-DT modules DIL-SWD-32-001 and DIL-SWD-32-002 forDILMa Connection of SmartWire-DT external device plugb Mechanical switching position indicatorc Diagnostics LEDd Catch slidere Connection pinsf Adjusting slide for contactor sizeg Terminal X0-X1-X2h Terminal, electrical enable X3-X4i Selector switch 1-0-A￫ For detailed instructions on how to connect the SmartWire-DTexternal device plug (SWD4-8SF2-5) to the 8-pin SmartWire-DTribbon cable, refer to the "Mount the external device plug" sec-tion in manual MN05006002Z-EN (previously AWB2723-1617en).acb dgfehacb dgfehi