Eaton SmartWire-DT SWD Series Manual

5 Connection PKE-SWD for motor-protective circuit-breaker PKE12/32/655.6 Exchange of modules128 SmartWire-DT module IP20 01/20 MN05006001Z-EN www.eaton.com5.6 Exchange of modulesAfter replacement of the modules and connection of the voltage the configu-ration button must be pressed. When this is done, the new module will beassigned an address.5.7 Device statusThe individual SmartWire-DT modules indicate their device status with theaid of a diagnosis LED. The diagnostics LED can have the following states:Table 17: Diagnostic messages of the SmartWire-DT status LED5.8 ParameterizationDepending on the coordinator being used, the module's parameters willneed to be configured in the programming system or in the SWD-Assist plan-ning and commissioning program.5.9 Fieldbus-specific characteristicsField bus EthercatPlease note the general information for configuring parameters ￫ Section12, „Using SWD modules with the EtherCAT field bus“, page 247.ATTENTIONThe order of the SmartWire-DT units must not be altered. DANGERThe exchange of the motor starter or contactor must only becarried out after the complete system SmartWire-DT isswitched off.Designation Color State MessageReady Green Continuous light Device is operating error-free.Flashing (1 Hz) • Addressing process in progress• after gateway power On• after actuation of the configuration button on the gateway• Module not in current configuration• invalid typeFlashing (3 Hz) • Communication to trip block PKE is interrupted