Eaton SmartWire-DT SWD Series Manual

2 I/O modules EU5E-SWD…2.7 Digital module EU5E-SWD-4DX30 SmartWire-DT module IP20 01/20 MN05006001Z-EN www.eaton.com2.7.4 InstallationFigure 11: Connecting inputs and power supply▶ Connect the sensors to the corresponding inputs I0 to I3. For the respec-tive power supply, use terminals I- (0 V) and I+ (24 V).▶ For a two-wire connection, connect the sensors to the correspondinginputs I0 to I3 and I- (0 V).▶ Connect the 24 V power supply for all modules.2.7.5 ParameterizationDepending on the coordinator being used, the module's parameters willneed to be configured in the programming system or in the SWD-Assist plan-ning and commissioning program.2.7.6 Fieldbus-specific characteristicsFieldbus EtherCATPlease note the general information for configuring parameters￫ Chapter 12 “Using SWD modules with the EtherCAT field bus”, page247, particularly￫ Section , „Device options“, page 247..2.7.7 ProgrammingThe module has two input bytes at its disposal.￫ All 0 V connections (Ix - ; x = 0, 1, 2, 3) are connected with eachother and with the module’s 0 V supply.0 V+-I024 V DC+-I1+-I2+-I324 V0 V1 2 30II0–I0+I0I1–I1+I1I2–I2+I2I3–I3+I3