Eaton SmartWire-DT SWD Series Manual

7 Pilot devices M22-SWD…7.2 M22-SWD front mount170 SmartWire-DT module IP20 01/20 MN05006001Z-EN www.eaton.comProfile 3 – RGB161 input byte, 3 output bytesThe 16-bit color is defined with one word that defines the red, green, andblue color components.OutputsByte 0:The LED is switched on and off with bit 0.By changing the content of bits 5 to 7, the brightness can be reduced to anyof seven settings.Table 39: Brightness settingBy changing the content of bits 3 to 4, the LED's flashing frequency can bedefined. If both bits have a state of "0", the LED will not flash even if a mark-to-space ratio has been set.Table 40: Flashing frequency settingsBy changing the content of bits 1 to 2, the mark-to-space ratio for LED flash-ing can be defined. If both bits have a state of "0", there will be no flashingeven if a flashing frequency has been set.7 6 5 4 3 2 1 0Brightness ?Frequency Flashing LEDon/offBit 7 Bit 6 Bit 50 0 0 Full brightness0 0 1 First dimming setting- - - …1 1 1 Seventh dimming setting￫ Please note that when using mixed colors, there may be colordeviations in the last two dimming settings.Bit 4 Bit 30 0 No flashing0 1 1 Hz1 0 0.5 Hz1 1 2 Hz