Chapter 4 Settings — [DISPLAY OPTION] menuENGLISH - 1052) Press the button.f The [SHUTTER SETTING] screen is displayed.3) Press as to select [STARTUP].4) Press qw to switch the item.[OPEN] Starts projection with the shutter function disabled (shutter: open) when the power is turned on.[CLOSE] Starts projection with the shutter function enabled (shutter: closed) when the power is turned on.[FREEZE]Pause the projected image temporarily regardless of the playback of the external device.1) Press as to select [FREEZE].2) Press the button.f Press the Notef [FREEZE] is displayed on the screen when video is paused.[WAVEFORM MONITOR]Use the input signals from a connected external device to display in a waveform. Check whether video output (luminance) signal level is withinthe recommended range for the projector and adjust.1) Press as to select [WAVEFORM MONITOR].2) Press qw to switch the item.[OFF] Does not display the waveform monitor.[ON] Displays the waveform monitor.3) Press the 4) Press as to select any horizontal line.5) Press the button to switch the Select line to either luminance, red, green, or blue.f Line selection items switch each time the is pressed only when the waveform monitor is displayed.“Select line (luminance)” Displayed in white waveform.“Select line (red)” Displayed in red waveform.“Select line (green)” Displayed in green waveform.“Select line (blue)” Displayed in blue waveform.Notef Setting is also available by [FUNCTION BUTTON] (x page 122).f The waveform monitor cannot be displayed during [P IN P].f The waveform monitor turns off when [P IN P] is executed during waveform monitoring.f The waveform monitor is not displayed when on-screen display is hidden (off).Adjusting the waveformProject the luminance adjustment signal of a commercial test disk (0 % (0 IRE or 7.5 IRE) – 100 % (100 IRE)) and adjust.Signal levelImage displayable areaImage position
