|
Chapter 1 Preparation — About your projector24 - ENGLISHAbout your projectorRemote control13245768910 15121113141617Front TopBottom1 Power standby <v> buttonSets the projector to the state where the projector is switchedoff (standby mode) when the switch on theprojector is set to and in projection mode.2 Power on <b> buttonStarts projection when the switch on theprojector is set to when the power is switched off(standby mode).3 Remote control indicatorBlinks if any button in the remote control is pressed.4 Lens (, , ) buttonsAdjusts the projection lens. (x page 60)5 asqw buttonsUsed to navigate through the menu screen. (x page 67)6 buttonSwitches the on-screen display function on (display) or off(hide). (x page 62)7 Input selection (, , ,Switches the input signal to project. (x page 63)(SDI input is supported only for PT-RZ670.)8 buttonAssigns a frequently used operation as a shortcut button.(x page 64)9 Number (<0> - <9>) buttonsUsed for entering an ID number or a password in a multipleprojector environment.10 buttonAutomatically adjusts the image display position while projectingthe image.[PROGRESS] is displayed while in automatic adjustment.(x page 64)11 buttonUsed to temporarily turn off the image. (x page 62)12 buttonDisplays the test pattern. (x page 64)13 buttonDisplays the projector information.14 buttonResets the content of the sub-menu to the factory default.(x page 68)15 buttonSets the ID number of the remote control in a multiple projectorenvironment. (x page 27)16 Remote control signal transmitter17 Remote control wired terminalThis is the terminal used to connect to the projector via a cablewhen used as a wired remote control. (x page 28)Attentionf Do not drop the remote control.f Avoid contact with liquids or moisture.f Do not attempt to modify or disassemble the remote control.Notef When operating the remote control by directly pointing at the remote control signal receiver of the projector body, operate the remotecontrol within a distance approx. 30 m (98'5") from the remote control signal receiver. The remote control can control at angles of up to ±30°vertically and horizontally, but the effective control range may be reduced.f If there are any obstacles between the remote control and the remote control signal receiver, the remote control may not operate properly.f The signal will be reflected off the screen. However, the operating range may be limited from light reflection loss due to the screen material.f If the remote control signal receiver directly receives strong light, such as fluorescent light, the remote control may not operate properly. Useit in a place distant from the light source.f The power indicator will blink if the projector receives a remote control signal.
|
