Chapter 4 Settings — [DISPLAY OPTION] menu106 - ENGLISH1) Select “Select line (luminance)” on the waveform monitor.2) Adjust black level.f Use [BRIGHTNESS] in the on-screen menu [PICTURE] to adjust the black level 0 % of the video signal to the 0 % position of thewaveform monitor.3) Adjust white level.f Use [CONTRAST] in the on-screen menu [PICTURE] to adjust the white level 100 % of the video signal to the 100 % position of thewaveform monitor.Adjusting red, green, and blue1) Set [COLOR TEMPERATURE] to [USER1] or [USER2] (x page 73).2) Select “Select line (red)” on the waveform monitor.3) Adjust dark red areas.f Use [RED] in [WHITE BALANCE LOW] to adjust the black level 0 % of the video signal to the 0 % position of the waveform monitor.4) Adjust bright red areas.f Use [RED] in [WHITE BALANCE HIGH] to adjust the white level 100 % of the video signal to the 100 % position of the waveformmonitor.5) Use the procedure for [RED] to adjust [GREEN] and [BLUE].Notef For DVI-D signal, HDMI signal, SDI signal, and DIGITAL LINK signal, confirm that the [SIGNAL LEVEL] setting is correct before adjustingthe black level. (SDI signal is supported only for PT-RZ670).[CUT OFF]Each red, green, and blue color component can be removed.1) Press as to select [CUT OFF].2) Press the button.f The [CUT OFF] screen is displayed.3) Press as to select [RED], [GREEN], or [BLUE].4) Press qw to switch the item.[OFF] Disables cutoff.[ON] Enables cutoff.Notef When input is switched or a signal is switched, the cutoff setting returns to its original setting (off).
