|
Chapter 3 Basic Operations — Switching on/off the projector58 - ENGLISHInitial setting (date and time)Set the local date and time. After completed the initial setting, you can change the setting from the [PROJECTOR SETUP] menu → [DATEAND TIME].To set the date and time automatically, refer to “Setting the date and time automatically” (x page 123).1) Press as to select an item.20XX7/711123456MONTHDAYHOURMINUTESECONDPlease set the date and time of the built-in clock of theprojector.INITIAL SETTINGSETCHANGEMENU SELECTYEARENTER2) Press qw to switch the setting.3) Press the button.f Confirm the setting value and complete the initial setting.Making adjustments and selectionsIt is recommended that images be projected continuously for at least 30 minutes before the focus is adjusted.6)1) 8) 5)3)7) 9)3)2)4)1) 5) 7) 8) 9)2)6)1) Press the button to roughly adjust the focus of the image. (x page 60)2) Change the setting of the [PROJECTOR SETUP] menu → [PROJECTION METHOD] depending on theinstallation mode. (x page 30)f Refer to “Navigating through the menu” (x page 67) for the operation of the menu screen.3) Press the input selection ( and , or , , , , ) button to select the input signal.(SDI input is supported only for PT-RZ670.)4) Adjust the front, back and sideway tilt of the projector with the adjustable feet. (x page 43)5) Press the button to adjust the position of the image.6) If the input signal is an RGB signal, press the button.7) Press the button to adjust the size of the image to match the screen.8) Press the button again to adjust the focus.9) Press the button again to adjust the zoom and the size of the image to match the screen.
|
