Chapter 4 Settings — [NETWORK] menu136 - ENGLISH7) When the confirmation screen is displayed, press qw to select [OK], and press the button.Notef The projector does not support 10BaseT Full/Half.When the projector is connected to a twisted-pair-cable transmitter1) Press as to select [DIGITAL LINK SETUP].2) Press the button.f The [DIGITAL LINK SETUP] screen is displayed.3) Press as to select [DUPLEX(DIGITAL LINK)].4) Press qw to switch the communication method.f The items will switch each time you press the button.[100BaseTX-Full] Full-duplex communication method is set.[100BaseTX-Half] Half-duplex communication method is set.[AUTONEGOTIATION] Sets the communication method automatically.5) Press as to select [STORE].6) Press the button.7) When the confirmation screen is displayed, press qw to select [OK], and press the button.[DIGITAL LINK STATUS]Display the DIGITAL LINK connection environment.1) Press as to select [DIGITAL LINK STATUS].2) Press the button.f The [DIGITAL LINK STATUS] screen is displayed.[LINK STATUS] Either [NO LINK], [DIGITAL LINK], or [ETHERNET] is displayed.[HDCP STATUS] Either [NO SIGNAL], [OFF], or [ON] is displayed.[SIGNAL QUALITY][SIGNAL QUALITY] is a numerical value of the amount of error, and the display color changes togreen, yellow, or red depending on that value.Check the signal quality level while receiving a signal from the twisted-pair-cable transmitter.f [MAX]/[MIN]: Maximum/minimum value of the amount of errorf Green (- 12 dB or lower) → Normal signal quality levelf Yellow (- 11 to -8 dB) → Warning level where there is the possibility of noise introduced on thescreenf Red (- 7 dB or higher) → Abnormal level where synchronization may be interrupted, or a signal maynot be received[NETWORK SETUP]Perform the initial setting of the network before using the network function.1) Press as to select [NETWORK SETUP].2) Press the button.f The [NETWORK SETUP] screen is displayed.3) Press as to select an item, and change the settings according to the operation instructions of themenu.[PROJECTOR NAME] Allows to change the projector name. Enter the host name if it is required in such a case when youuse a DHCP server.[DHCP][ON] If a DHCP server exists in the network where the projector is to beconnected, obtains the IP address automatically.[OFF]If a DHCP server does not exist in the network where the projectoris to be connected, set [IP ADDRESS], [SUBNET MASK], and[DEFAULT GATEWAY].
