Chapter 4 Settings — [ADVANCED MENU] menu86 - ENGLISHBlanking correction Item Operation Adjustment Range of adjustmentTop of the screen [UPPER]Press q. The blanking zonemoves upward.PT-RZ670: Top to bottom0 - 599PT-RW630: Top to bottom0 - 399Press w. The blanking zonemoves downward.Bottom of thescreen [LOWER]Press w. The blanking zonemoves upward.Press q. The blanking zonemoves downward.Left side of thescreen [LEFT]Press w. The blanking zonemoves to the right.PT-RZ670: Left to right0 - 959PT-RW630: Left to right0 - 639Press q. The blanking zonemoves to the left.Right side of thescreen [RIGHT]Press q. The blanking zonemoves to the right.Press w. The blanking zonemoves to the left.[INPUT RESOLUTION]You can adjust to achieve an optimal image when there is a flickering image or smeared outlines.1) Press as to select [INPUT RESOLUTION].2) Press the button.f The [INPUT RESOLUTION] screen is displayed.3) Press as to select [TOTAL DOTS], [DISPLAY DOTS], [TOTAL LINES], or [DISPLAY LINES], and pressqw to adjust each item.f Values corresponding to the signal being input are displayed automatically for each item. Increase or decrease the displayed valuesand adjust to the optimal point viewing the screen when there are vertical stripes or sections are missing from the screen.Notef Previously mentioned vertical banding will not occur with all white signal input.f The image may be disrupted while performing the adjustment, but it is not a malfunction.f [INPUT RESOLUTION] can be adjusted only when an RGB signal is input to the terminal or the terminal.f Some signals may not be adjusted.[CLAMP POSITION]You can adjust the optimal point when the black part of the image is blunt or it has turned green.1) Press as to select [CLAMP POSITION].2) Press qw to adjust.Status Rough guide for optimal value Range of adjustmentThe black part is blunt. The point where bluntness of the black part improves the most isthe optimal value. 1 - 255The black part is green. The point where the green part becomes black, and the bluntnesshas improved is the optimal value.Notef [CLAMP POSITION] can be adjusted only when a signal is input to the terminal or the terminal.f Some signals may not be adjusted.
