Chapter 4 Settings — [NETWORK] menuENGLISH - 137[IP ADDRESS] Enter the IP address when you do not use a DHCP server.[SUBNET MASK] Enter the subnet mask when you do not use a DHCP server.[DEFAULT GATEWAY] Enter the default gateway address when you do not use a DHCP server.[STORE] Save the current network settings.4) Press as to select [STORE], and press the button.5) When the confirmation screen is displayed, press qw to select [OK], and press the button.Notef When using a DHCP server, confirm that the DHCP server is running.f Consult your network administrator regarding the IP address, subnet mask, and default gateway.f When [Art-Net SETUP] is set to [ON(2.X.X.X)] or [ON(10.X.X.X)], [NETWORK SETUP] cannot be selected.[NETWORK CONTROL]Set up the control method of the network.1) Press as to select [NETWORK CONTROL].2) Press the button.f The [NETWORK CONTROL] screen is displayed.3) Press as to select an item, and press qw to change the setting.[WEB CONTROL] Set to [ON] to control with the web browser.[PJLink CONTROL] Set to [ON] to control with the PJLink protocol.[COMMAND CONTROL] Set to [ON] to control with the / terminal control command format(x page 172). Refer to “Control commands via LAN” (x page 167).[COMMAND PORT] Set the port number used for command control.[Crestron Connected(TM)] Set to [ON] to control with Crestron Connected TM of Crestron Electronics, Inc.[AMX D.D.]Set to [ON] to control with the controller of AMX Corporation.Setting this function to [ON] enables detection through “AMX Device Discovery”. For details, refer tothe website of AMX Corporation.URL http://www.amx.com/[EXTRON XTP]Set to [ON] when connecting the “XTP transmitter” of Extron Electronics to the terminal.The [EXTRON XTP] setting must be set to [OFF] when connecting the optional Digital Interface Box(Model No.: ET-YFB100G).For details of the “XTP transmitter”, refer to the website of Extron Electronics.URL http://www.extron.com/[STORE] Save the current network control settings.4) Press as to select [STORE], and press the button.5) When the confirmation screen is displayed, press qw to select [OK], and press the button.[NETWORK STATUS]Display the status of the projector network.1) Press as to select [NETWORK STATUS].2) Press the button.f The [NETWORK STATUS] screen is displayed.[DHCP] Displays the status of use of the DHCP server.[IP ADDRESS] Displays the [IP ADDRESS].[SUBNET MASK] Displays the [SUBNET MASK].[DEFAULT GATEWAY] Displays the [DEFAULT GATEWAY].[DNS1] Displays the address of the primary DNS server.[DNS2] Displays the address of the secondary DNS server.[MAC ADDRESS] Displays the [MAC ADDRESS].
