Chapter 3 Basic Operations — Operating with the remote controlENGLISH - 63Switching the inputThe input for projection can be switched.button1) Press the input selection (, , , f This operation can be also performed using the buttons on the control panel. Switches the input to RGB1 or RGB2. Switches to the other input when one input has already beenchosen. Switches the input to DIGITAL LINK. Switches the input to DVI-D.*1 Switches the input to RGB1.*2 Switches the input to SDI. Switches the input to HDMI.*1 The operation is disabled in the factory default settings. The operation is enabled when [REMOTE CONTROL] is set to [USER] and [VIDEOBUTTON] of [INPUT SELECT BUTTON] is set to other than [DISABLE], from the [SECURITY] menu → [CONTROL DEVICE SETUP].*2 SDI input is supported only for PT-RZ670.Notef When the optional Digital Interface Box (Model No.: ET-YFB100G) is connected to the terminal, the input onET-YFB100G changes with each press of the button. The input can also be changed using the RS-232C control command.For twisted-pair-cable transmitters of other manufacturers, switch the input on the projector to DIGITAL LINK, and then switch the input onthe twisted-pair-cable transmitter.Using the Status functionYou can display the status of the projector.button1) Press the button.f The [STATUS] screen is displayed.100000h100000h / 100000h1.00 / 1.001/431°C/87°F27°C/80°F31°C/87°F31°C/87°F31°C/87°F1013hPaMENU EXITCHANGEENTER SEND E-MAILSELF TESTATMOSPHERIC PRESSUREAUTO - FLOORNO ERRORSCOOLING CONDITIONAROUND LIGHT2 TEMP.AROUND LIGHT1 TEMP.EXHAUST AIR TEMP.OPTICS MODULE TEMP.INTAKE AIR TEMP.MAIN/SUB VERSIONLIGHT RUNTIMEPROJECTOR RUNTIMEPROJECTOR TYPE RZ670(SW1234567)STATUSNotef This can be displayed from the [PROJECTOR SETUP] menu → [STATUS] (x page 120).
