Chapter 4 Settings — [ADVANCED MENU] menu88 - ENGLISH15) Press as to select [UPPER], [LOWER], [LEFT], or [RIGHT] in [BLACK BORDER WIDTH].16) Press qw to set the region (width) of the [BLACK BORDER WIDTH] adjustment.f When PT-RZ670 is used, proceed to Step 17).f When PT-RW630 is used, proceed to Step 19).17) Press as to select [UPPER KEYSTONE AREA], [LOWER KEYSTONE AREA], [LEFT KEYSTONEAREA], or [RIGHT KEYSTONE AREA].18) Press qw to adjust the tilt of the border between [NON-OVERLAPPED BLACK LEVEL] and [BLACKBORDER LEVEL].19) Press as to select [BLACK BORDER LEVEL].20) Press the button.f The [BLACK BORDER LEVEL] screen is displayed.f If [INTERLOCKED] is set to [OFF], [RED], [GREEN], and [BLUE] can be adjusted individually.21) Press as to select an item, and press qw to adjust the setting.[BLACK BORDER WIDTH] (Right)Projection range Edge blending [WIDTH] (Right)[MARKER] (Red)Edge blending [START] (Right)([MARKER] (Green))[BLACK BORDER LEVEL][OVERLAPPED BLACK LEVEL] (Right)[NON-OVERLAPPED BLACK LEVEL]Notef [BRIGHTNESS ADJUST] is a function that makes the increased brightness in black level of the overlapping image area difficult tonotice when [EDGE BLENDING] is used to configure multiple screens. The optimal amount of correction can be set by adjusting [NON-OVERLAPPED BLACK LEVEL] so that the black level of the overlapping image area will be the same as that of the non-overlapping area.If the border area between the image overlapping part and non-overlapping part gets brighter after adjusting [NON-OVERLAPPED BLACKLEVEL], adjust the width of the top, bottom, left, or right. Adjust [BLACK BORDER LEVEL] when the width adjustment makes only theborder area darker.f The joining part may look discontinuous depending on the position you are looking from when a screen with high gain or rear screen is used.f When configuring multiple screens using both horizontal and vertical edge blending, adjust [OVERLAPPED BLACK LEVEL] first beforemaking adjustments in Step 12). Adjustment method is the same as the procedure of [NON-OVERLAPPED BLACK LEVEL].f If only horizontal or only vertical edge blending is used, set all items in [OVERLAPPED BLACK LEVEL] to 0.f [AUTO TESTPATTERN] settings change together with the [AUTO TESTPATTERN] of [COLOR MATCHING].f Adjustment of the tilt of the border between [NON-OVERLAPPED BLACK LEVEL] and [BLACK BORDER LEVEL] is a function to performedge blending together with the adjustment of [GEOMETRY] (x page 81). If [NON-OVERLAPPED BLACK LEVEL] is tilted by correctingthe keystone distortion with [KEYSTONE] in [GEOMETRY], perform Steps 17) 18) to adjust the edge blending according to the shape of[NON-OVERLAPPED BLACK LEVEL].f When the keystone distortion is corrected with [KEYSTONE], the edge blending cannot be adjusted together. (Only for PT-RW630)[FRAME RESPONSE]Set image frame delay.1) Press as to select [FRAME RESPONSE].2) Press qw to switch the item.f The items will switch each time you press the button.[NORMAL] Standard setting.[FAST]*1 Simplifies the image processing to reduce image frame delay.[FIXED]*2 Sets image frame delay to be constant regardless of the image position or magnification.*1 When input signals are other than interlaced signals, [FAST] cannot be set.*2 Only when movie-based signals and still image signals with the vertical scanning frequency of 50 Hz or 60 Hz are inputNotef When [FRAME RESPONSE] is set to [FAST], picture quality deteriorates. Also, [DIGITAL CINEMA REALITY] cannot be set.f [FRAME RESPONSE] cannot be set during P IN P.
