Chapter 4 Settings — [DISPLAY OPTION] menuENGLISH - 993) Press as to select [EDID MODE].4) Press the button.f The [DIGITAL LINK EDID MODE] screen is displayed.5) Press qw to switch [EDID MODE].f The items will switch each time you press the button.[DEFAULT] Standard setting.[SCREEN FIT] Changes data of EDID according to the setting of [SCREEN FORMAT].[USER] Sets [RESOLUTION] or [VERTICAL SCAN FREQUENCY] item to EDID.f When [DEFAULT] or [SCREEN FIT] is selected, proceed to Step 10).6) Press the button.f The [RESOLUTION] screen is displayed.7) Press asqw to select [RESOLUTION].f Select [1024x768p], [1280x720p], [1280x768p], [1280x800p], [1280x1024p], [1366x768p], [1400x1050p], [1440x900p], [1600x900p],[1600x1200p], [1680x1050p], [1920x1080p], [1920x1080i], or [1920x1200p].8) Press the button.f The [VERTICAL SCAN FREQUENCY] screen is displayed.9) Press qw to select [VERTICAL SCAN FREQUENCY].f Select [60Hz], [50Hz], [48Hz], [30Hz], [25Hz], or [24Hz].f [48Hz] can be selected only when [1920x1080i] is selected for [RESOLUTION].f [30Hz], [25Hz], or [24Hz] can be selected only when [1920x1080p] is selected for [RESOLUTION].10) Press the button.f The confirmation screen is displayed.11) Press qw to select [OK], and press the button.Notef The setting details are displayed in [RESOLUTION] and [VERTICAL SCAN FREQUENCY] of [EDID STATUS].f The resolution and vertical scanning frequency settings may be required on your computer or video device.f After configuring settings, your computer or video device or the projector may be required to be restarted.f Output with resolution and vertical scanning frequency that have been set may not be performed depending on your computer or videodevice.[SDI IN](Only for PT-RZ670)Set this item according to the signal to be input to the terminal.Setting [SIGNAL LEVEL]Select the amplitude of the signal to input.1) Press as to select [SDI IN].2) Press the button.f The [SDI IN] screen is displayed.3) Press as to select [SIGNAL LEVEL].4) Press qw to switch the item.[64-940] Normally use this setting.[4-1019] Select when gray is displayed as black.Setting [BIT DEPTH]1) Press as to select [SDI IN].2) Press the button.f The [SDI IN] screen is displayed.
