|
Chapter 1 Preparation — About your projector26 - ENGLISHr Control panel91011121314243156781 Power on <b> buttonStarts projection when the switch on theprojector is set to when the power is switched off(standby mode).2 Power standby <v> buttonSets the projector to the state where the projector is switchedoff (standby mode) when the switch on theprojector is set to and in projection mode.3 buttonSwitches the input to RGB1.4 buttonSwitches the input to RGB2.5 buttonSwitches the input to DVI-D.6 buttonSwitches the input to HDMI.7 buttonSwitches the input to DIGITAL LINK.8 buttonSwitches the input to SDI.(Only for PT-RZ670)9 Displays or hides the main menu. (x page 67)Returns to the previous menu when a sub-menu is displayed.If you press the three seconds while the on-screen display is off (hidden), theon-screen display is turned on.10 buttonAdjusts the focus, zoom, and shift (position) of the lens.11 buttonDetermines and executes an item in the menu screen.12 buttonUsed to temporarily turn off the image. (x page 62)13 asqw buttonsUsed to select items in the menu screen, change settings, andadjust levels.Also used to enter a password in [SECURITY] or entercharacters.14 buttonAutomatically adjusts the image display position while projectingthe image. [PROGRESS] is displayed while in automaticadjustment. (x page 64)r Connecting terminals1 2 3 45 6 7 8 9 101 terminal/ terminalThese are the terminals to connect the remote control for serialcontrol in a multiple projector environment.2 terminalThis is a terminal to remotely control the projector using theexternal control circuit.3 terminalThis is the RS-232C compatible terminal to externally controlthe projector by connecting a computer.4 terminalThis is a terminal to output the signal connected to the IN> terminal.5 terminalThis is the terminal to input SDI signals.(Only for PT-RZ670)6 ( R/VIDEO>, , B/C>, ,) terminalsThese are terminals to input RGB signals, YCBCR /YPBPRsignals, Y/C signals, or video signals.7 terminalThis is a terminal to input RGB signals or YCBCR /YPBPR signals.8 terminalThis is the terminal to input DVI-D signals.9 terminalThis is the terminal to input HDMI signals.10 terminalThis is the LAN terminal to connect to the network. This is alsoused when connecting a video signal transmission device viathe LAN terminal.Attentionf When a LAN cable is directly connected to the projector, the network connection must be made indoors.
|
