Chapter 6 Appendix — Technical informationENGLISH - 173r Lens control commandCommand Sub command Details RemarkVXX LNSI2 Lens H shift+00000 = Fine adjustment 1+, +00001 = Fine adjustment 1- , +00100= Fine adjustment 2+, +00101 = Fine adjustment 2-, +00200 = Coarseadjustment+, +00201 = Coarse adjustment-VXX LNSI3 Lens V shiftVXX LNSI4 Lens focusVXX LNSI5 Lens zoom terminalIt is possible to control the projector remotely (by external contact) from a control panel located away from the projector where remote controlsignals cannot reach.Use the terminal on the connecting terminals of the projector to connect to the control panel.Remote control Contact controlRemote control/contact controlStandby LitLight sourceRGB1 DIGITAL LINKRGB2 HDMIDVI-DInstallation locations such as a meeting room Remote control board in another locationPin assignments and signal namesD-Sub 9-pinOutside view Pin No. Signal name Open (H) Short (L)(9) (6)(5) (1)(1) GND ― GND(2) POWER OFF ON(3) RGB1 Other RGB1(4) RGB2 Other RGB2(5) DIGITAL LINK Other DIGITAL LINK(6) HDMI Other HDMI(7) DVI-D Other DVI-D(8) SHUTTER OFF ON(9) RST/SET Controlled by remotecontrolControlled by externalcontactAttentionf When controlling, make sure to short-circuit pins (1) and (9).f When pins (1) and (9) are short-circuited, the following buttons on the control panel and the remote control are disabled. Commands forRS-232C and network functions corresponding to these functions are also disabled.g Power on <b> button, power standby <v> button, buttonf When pins (1) and (9) are short-circuited, and then any pins from (3) to (7) and the pin (1) are short-circuited, the following buttons on thecontrol panel and the remote control are disabled. Commands for RS-232C and network functions corresponding to these functions are alsodisabled.g Power on <b> button, power standby <v> button, button, button, button, button, button, button, button, button(SDI input is supported only for PT-RZ670.)Notef For pin (2) to pin (8) settings, you can make changes if you set [REMOTE2 MODE] to [USER]. (x page 122)
