Chapter 4 Settings — [PROJECTOR SETUP] menuENGLISH - 1212) Press the button.f The [STATUS] screen is displayed.3) Press qw to switch the pages.f The page will change each time you press the button.[PROJECTOR TYPE] Displays the projector type and serial number of the projector.[PROJECTOR RUNTIME] Displays the runtime of the projector.[LIGHT RUNTIME] Displays the runtime of the light source 1 and 2.[MAIN/SUB VERSION] Displays the main and sub versions of the firmware of the projector.[INTAKE AIR TEMP.]*1 Displays the status of the intake air temperature of the projector.[OPTICS MODULE TEMP.] *1 Displays the status of the internal temperature of the projector.[EXHAUST AIR TEMP.]*1 Displays the status of the exhaust air temperature of the projector.[AROUND LIGHT1 TEMP.]*1 Displays the status of the temperature around light source 1 of the projector.[AROUND LIGHT2 TEMP.]*1 Displays the status of the temperature around light source 2 of the projector.[COOLING CONDITION] Displays the set cooling conditions. When [AUTO] is set, automatically recognized result is displayed.[ATMOSPHERIC PRESSURE] Displays the atmospheric pressure.[SELF TEST] Displays the status of the projector.[INPUT] Displays the input terminal currently selected.[BACKUP INPUT STATUS] Displays the backup status.[SIGNAL NAME] Displays the input signal name.[SIGNAL FREQUENCY] Displays the frequency of the input signal.[ON COUNT] [POWER ON TIMES] Displays the number of times the power is turned on.[NUMBER OF REGISTEREDSIGNAL] Displays the number of registered signals.[REMOTE2 STATUS] Displays the control status of the REMOTE2.[AC VOLTAGE] Displays the status of the AC voltage.[UPGRADE]*2[ET-UK20] Displays the activation status based on the Upgrade Kit (Model No.:ET-UK20).[ET-CUK10] Displays the activation status based on the Auto Screen AdjustmentUpgrade Kit (Model No.: ET-CUK10).[SIGNAL INFORMATION][MEMORY NO.] Displays the memory number of the input signal.[INPUT] Displays the input terminal currently selected.[SIGNAL NAME] Displays the input signal name.[SIGNAL FREQUENCY] Displays the frequency of the input signal.[SYNC.STATE] Displays the synch polarity of the input signal.[V.SYNC WIDTH] Displays the vertical sync signal pulse width of the input signal.[SCAN TYPE] Displays the scan type of the input signal.[TOTAL DOTS] Displays the total dot count of the input signal.[DISPLAY DOTS] Displays the number of input signal display dots.[TOTAL LINES] Displays the total line count of the input signal.[DISPLAY LINES] Displays the number of input signal display lines.[SAMPLING] Displays the sampling information of the input signal.[SIGNAL LEVEL] Displays the signal level of the input signal.[BIT DEPTH]*2 Displays the gradation of the input signal.*1 The temperature status is indicated with text color (green/yellow/red) and bar scale. Use the projector within the range that the indication isgreen.*2 Only for PT-RZ670Notef E-mail including the content of status can be sent to the E-mail addresses (up to two addresses) set in “[E-mail set up] page” (x page 149)by pressing the button while displaying the [STATUS] screen.f Some items in [SIGNAL INFORMATION] may be displayed and others not displayed, depending on the signal being input.f If any abnormality has occurred on the projector, pressing the button while the [STATUS] screen is displayed shows the detailscreen of the error information.f For details on the contents displayed in [SELF TEST], refer to “[SELF TEST] indications” (x page 162).[NO SIGNAL SHUT-OFF]A function that automatically switches the power source of the projector to standby if there is no input signal for a certain period of time. Thetime before switching to standby can be set.1) Press as to select [NO SIGNAL SHUT-OFF].
