SettingTerminal Status <1> Detection Method <2> Stopping MethodN.O. N.C. AlwaysDetectedDetectedduring RunonlyRamp to Stop(fault) Coast to Stop(fault) Fast-stop(fault)Alarm Only(continuerunning)2E O O O2F O O O<1> Determine the terminal status for each fault, i.e., whether the terminal is normally open or normally closed.<2> Determine whether detection for each fault should be enabled only during run or always detected.Setting 40/41: Forward Run/Reverse Run Command for 2-Wire SequenceSets the drive for 2-Wire sequence.When the input set to 40 is closed, the drive operates in the forward direction. When the input set for 41 is closed, the drivewill operate in reverse. Closing both inputs at the same time will result in an external fault.Note: These functions are assigned to the terminals S1 and S2 when the drive is initialized for 2-Wire sequence.S1S2SCDriveForward RunReverse RunDigital Input CommonFigure 5.19 Example Wiring Diagram for 2-Wire SequenceSetting 61/62: Speed Search 1/2These input functions can be used to enable Speed Search. When the Speed Search 1 input (H1-oo = 61) is enabled the drivewill search the motor speed starting from the maximum output frequency. With Speed Search 2 input (H1-oo = 62) enabledthe Speed Search will be performed starting from the frequency reference.Note: Operator error oPE03 will result if both Speed Search 1 and Speed Search 2 are set to the input terminals at the same time.Setting 67: Communication Test ModeIf a RS-422/485 communications options is attached to the drive, this function can be used to perform a self-diagnosis of thecommunication interface. The drive transmits data and then confirms the communications are received normally. Refer toSelf-Diagnostics on page 232 for details on how to use this function.u H2: Multi-Function Outputn H2-01: Terminal MA/MB/MC Function SelectionThe drive has a multi-function output terminal. Set parameter H2-01 between 0 and 13D to assign functions to this terminal.Default values are listed in the following table.No. Parameter Name Setting Range DefaultH2-01 Terminal MA, MB and MC Function Selection (relay) 0 to 13D E: FaultNote: If not using an input terminal or if using it in the through-mode, be sure to set that terminal to “F”.Table 5.16 Multi-Function Output Terminal SettingsSetting Function Page Setting Function Page0 During Run 104 E Fault 1061 Zero Speed 104 F Not used/Through Mode 1062 Speed Agree 104 10 Alarm 1074 Frequency Detection 1 105 17 Torque Detection 1 (N.C.) 1065 Frequency Detection 2 105 1A During Reverse Operation 1076 Drive Ready 106 1E Restart Enabled 1075.6 H: Terminal FunctionsYASKAWA ELECTRIC SIEP C710606 31B YASKAWA AC Drive – J1000 Technical Manual 1035 Parameter Detailshttp://nicontrols.com
