NOTICEObserve proper electrostatic discharge procedures (ESD) when handling the drive and circuit boards.Failure to comply may result in ESD damage to the drive circuitry.Never connect or disconnect the motor from the drive while the drive is outputting voltage.Improper equipment sequencing could result in damage to the drive.Do not perform a withstand voltage test on any part of the drive.Failure to comply could result in damage to the sensitive devices within the drive.Do not operate damaged equipment.Failure to comply could result in further damage to the equipment.Do not connect or operate any equipment with visible damage or missing parts.Install adequate branch circuit short circuit protection per applicable codes.Failure to comply could result in damage to the drive.The drive is suitable for circuits capable of delivering not more than 31,000 RMS symmetrical Amperes, 240 Vac maximum(200 V Class) and 480 Vac maximum (400 V Class).Do not expose the drive to halogen group disinfectants.Failure to comply may cause damage to the electrical components in the drive.Do not pack the drive in wooden materials that have been fumigated or sterilized.Do not sterilize the entire package after the product is packed.u Drive Label WarningsAlways heed the warning information listed in Figure i.1 in the position shown in Figure i.2.Risk of electric shock.WARNINGRead manual before installing.Wait 1 minute for capacitor discharge afterdisconnecting power supply.To conform to requirements, make sureto ground the supply neutral for 400V class.Figure i.1 Warning InformationWarningLabelFigure i.2 Warning Information Positioni.2 General SafetyYASKAWA ELECTRIC SIEP C710606 31B YASKAWA AC Drive – J1000 Technical Manual 13http://nicontrols.com
